Rockwell Automation DC3R Regenerative DC Drive User Guide 1/4 - 2 HP, 115/230 VAC - Manual (Page 52)

44
CE Compliance
Reliance Electric hereby certifies that its DC3 series drives have been
approved to bear the “CE” mark provided the conditions of approval
(listed in Exhibit “A”) have been met by the end user.
The DC3 series has been tested to the following test specifications:
EN55011:1991 (emissions), and
EN50082-1:1992 (immunity)
Compliance allows Reliance Electric’s DC3 series to bear the CE mark.
The end user, as described herein, falls into one of two categories:
1. The Consumer will deploy a stand-alone unit as an integral, yet
external, portion of the machine he/she is operating.
2. The Original Equipment Manufacturer (OEM) will implement the
product as a component of the machine being manufactured.
Exhibit “A”: Line Filters
In addition to EMI/RFI safeguards inherent in the DC3 series’ design,
external filtering is required.
Reliance Electric requires the Corcom® filters listed in Table 3. If the
exact filter is not available, the specifications are as follows:
L = 1.8 milliHenries.
C = 0.01 microFarad (Line to Ground); 1.1 microFarads (Line to
Line).
Discharge Resistor = 330Kohms.
Rated current: 1.4 times maximum DC motor current.
Filter type: Balanced 2-section.