Rockwell Automation T3464 ICS Regent AC Guarded Digital Output Module - Manual (Page 11)

(T3464) AC Guarded Digital Output Module
P D - 6 0 2 1 M a r - 0 6
11
Figure 5. Fault Tolerant Configuration with Redundant
Actuators.
Field Wiring
Field wiring terminal blocks on the I/O chassis are used to
connect power sources and loads to the module. The terminal
blocks are located directly above and below the slot where the
module is installed. Each terminal block consists of ten #6
wire clamp screw terminals capable of holding two 12-AWG
wires.
Each module has separate power line and neutral terminals
for each output group (group 1: channels 1-8, group 2:
channels 9-16). The two groups are electrically isolated from
each other (2500 volts minimum). Figure 6 shows the proper
field wiring for a single module and Figure 7 shows the field
wiring for fault tolerant modules connected in parallel.