Rockwell Automation T3834 ICS Regent Continuous Control Package for Winterpret - Manual (Page 15)

Continuous Control Package for W INTERPRET (T3834)
P D - 6 0 4 4 M a r c h , 0 6
15
Low Integral Windup Alarm
On if the integral error is smaller than the low integral
value.
High Integral Windup Alarm
On if the integral alarm error is larger than the high
integral value.
Maximum Error Alarm
On when the error term is larger than the maximum error.
Maximum Error Rate Alarm
On when the rate of change for the error exceeds the
maximum error rate.
Setpoint Low Alarm
On when the setpoint is lower than the setpoint low limit.
Setpoint High Alarm
On when the setpoint is higher than the setpoint high
limit.
Deviation Low Alarm
On when the change about the setpoint is smaller than the
deviation low limit.
Deviation High Alarm
On when the change about the setpoint is larger than the
deviation high limit.
Negative Deviation
On to indicate the controller output is decreasing.
Control On Status
On to indicate that the control loop is running in automatic
mode, off to indicate that the control loop is running in
manual mode or algorithm cannot be calculated in
automatic mode.
Edit Controller
The Edit Controller command lets you edit a controller.
The Edit Controller command brings up the same dialog as
add/insert controller, but with the values filled in.
Delete Controller
The Delete Controller command deletes a controller from
the function block.