Rockwell Automation T3834 ICS Regent Continuous Control Package for Winterpret - Manual (Page 21)

Continuous Control Package for W INTERPRET (T3834)
P D - 6 0 4 4 M a r c h , 0 6
21
Note: In order to tune a controller while it is running in a
Regent, each parameter to be tuned should be defined as a
variable (shared variables may be defined with initial
values, local variables may not). The Data Monitor should
be used to change the values of the variables as required.
Monitor Controller
The Monitor Controller command displays the dialog box
shown in Figure 8. In order that the whole dialog can be
viewed on systems with VGA resolution, this dialog
displays only ‘key’ variables.
Figure 8. Monitor Controller Dialog Box.
Search Menu
The Search Menu provides commands to locate
information in a continuous controller function block. You
can choose Go to Controller (to move to a particular control
loop), Find (to search for text strings) or Find Next (to
repeat the last Find selection).