Rockwell Automation T3431-CA ICS Regent Thermo Couple Input Assembly - Manual (Page 20)

Thermocouple Input Assembly (T3431)
2 0
Industrial Control Services
Table 3. Slot Key Positions.
Module Upper
Connector
Lower
Connector
T3431 15 15
Configuration
Each input module is configured using the W INTERPRET I/O
Configuration Editor. In the editor, you will perform the
three steps described below to configure the input module.
1) Set the Module Type:
Position the cursor on the module slot you wish to define.
Choose Set Module Type from the Edit Menu and select
the thermocouple input module from the list.
2) Edit the Module Definition:
Choose Edit Module Definition from the Edit Menu. A
dialog box will open where you can define the input point
definitions.
Figure 12. Thermocouple Input Module Definition.
3) Edit each point:
Position the cursor on a Point definition and choose Edit
from the Module Definition dialog box to define a name
and description for each input point. In the Thermocouple
Input Point dialog, enter a tag name (up to 12 characters)
and a description (up to 40 characters). The tag names are