Rockwell Automation Liqui-Flo 1.5 AC Power Modules V1.2 - Manual (Page 29)

Mounting the Drive, Grounding, and Finding Wire Routing Locations 4-1
C
HAPTER
4
Mounting the Drive, Grounding, and
Finding Wire Routing Locations
This chapter shows how to mount the drive and properly ground it. Also shown are the
entry areas where wiring is to be routed in and out of the drive.
4.1 Lifting and Mounting the Drive
Use the following procedure to lift the LiquiFlo 1.5 drive and mount it in the required
enclosure:
Step 1. For M/N LF150500R4, LF150500W4, LF150643R4, or LF150643W4, install
two eyebolts into the drive to serve as lifting points. Two 3/4” nuts are welded
to the drive’s baseplate. Screw two eyebolts (2” eye I.D., 6” long shank) into
the nuts.


For M/N LF150414R4 or LF150414W4, install two clevis clamps into the
drive to serve as lifting points. Two 9/16” through holes are machined into the
casting protrusions.


For M/N LF151200R4 or LF151200W4, install two clevis pins into the drive
to serve as lifting points. Two 1.00" through holes are provided in the sheet
metal chassis.
Step 2. For M/N LF150414R4, LF150414W4, M/N LF150500R4, LF150500W4,
LF150643R4, or LF150643W4, connect 18” (nominal) of chain between the
eyebolts or attached clevis clamps and secure them with a clevis clamp.


For M/N LF151200R4 or LF151200W4, connect 50" (nominal) of chain
between the eyebolts or attached clevis clamps and secure them with a
clevis clamp.
Step 3. Using an overhead or portable hoist (minimum 1/2 ton rated capacity), attach
a free-fall chain to the chain secured to the drive. Take up any vertical slack in
the chain.
Step 4. Using the hoist, lift the drive from the horizontal shipping pallet.
Step 5. Position the drive in the enclosure.
Step 6. For M/N LF150414R4, LF150414W4, M/N LF150500R4, LF150500W4,
LF150643R4, or LF150643W4, attach the drive to the vertical surface
selected using the four (4) mounting holes provided.


For M/N LF151200R4 or LF151200W4, attach the drive to the vertical
surface using the six (6) mounting holes provided.