Rockwell Automation 20B PowerFlex 700 Dynamic Brake Kit - Manual

Installation Instructions
PowerFlex 700/700S Frame 5 Drives 600/690V Brake Bus Bar
Insulator Installation
Catalog Numbers 20B, 20D
Before You Begin These instructions apply only to frame 5 PowerFlex® 700 and PowerFlex 700S
AC drives. You can verify your drive frame size by checking the data nameplate on
the side of the drive.
ATTENTION: Allow only qualified personnel, familiar with AC drives and
associated machinery, to plan or implement the installation, start-up and
subsequent maintenance of the system. Failure to comply can result in personal
injury and/or equipment damage.
ATTENTION: This drive contains Electrostatic Discharge (ESD) sensitive parts
and assemblies. Static control precautions are required when you install, test,
service, or repair this assembly. If ESD control procedures are not followed,
component damage can result. If you are not familiar with static control
procedures, see the Guarding Against Electrostatic Damage, publication
8000-
4.5.2 or any other applicable ESD protection handbook.
IMPORTANT The drive catalog number, 20B in this example, identifies a PowerFlex 700
drive. Verify that the serial number on your drive data nameplate matches a
serial number that is identified in the Product Safety Advisory (PSA)
#2014-06-003.
Cat No. 20B D xxx x x xxxxxxx
Made in the USA (TAC 1J)
Rockwell Automation, Mequon WI 53092-4400
UL TYPE 1/IP20
Mfd. in 2007 on Aug 1 Frame: 5
Series: B
I/O: 24VAC/DC (Standard)
Original Firmware V. x.xxx
Listed
Ind. Cont
Eq. 966X
U
c
US
L
®
Normal Duty Power
Heavy Duty Power
AC Voltage Range
Amps
Input: 3 Phase, 47-63Hz
Output: 3 Phase, 0-400 Hz
AC Voltage Range
Base Hz (default)
Continuous Amps
1 Min Overload Amps
3 Sec Overload Amps
xxx kW
xxx kW
342-440
xxx
0-400
50 Hz
xxx
xxx
xxx
xxx kW
xxx kW
432-528
xxx
400V 480V
0-460
60 Hz
xxx
xxx
xxx
N223
Serial Number: xxxxxxx
Drive Frame Size
Drive Serial Number