Rockwell Automation MPP Processor Moduile - Manual (Page 14)

14 MPP October 2005 – Issue 6
Triguard SC300E
Configuration registers
The MPP is configured by setting 8-bit DIP switches S1 and S2 as listed in Table 2-3 and
Table 2-4.
Chassis address link settings
The correct link combination for the main chassis is shown in Figure 2-5 .
The physical locations of the chassis address setting links are indicated by small triangles in
columns ‘b’ and ‘c’ of areas ‘d’ in Table 2-2. On the chassis backplane and in the links are
identified as UNIT ID0 to UNIT ID3.
Figure 2-5 Main chassis link address settings