Rockwell Automation 1769-L30ER_L30ERM_L30ER-NSE_L33ERM_L33ER_L36ERM CompactLogix 5370 L3 Controllers Quick Start - Manual (Page 53)

Rockwell Automation Publication IASIMP-QS023B-EN-P - December 2012 53
Chapter
4
Configure the DeviceNet Network
In this chapter, you configure the DeviceNet node address for the 1769-SDN module. You also
create the RSNetWorx for DeviceNet file that stores network configuration.
Before You Begin
Before you begin, complete these tasks:
• The tasks described in Chapter 1, Prepare the CompactLogix 5370 L3 Controller
Hardware on page 17 , including the following:
– Install the EtherNet/IP network
– Install the controller and the local expansion module 1769-OB16 output module
– Wire power to the controller
– Make network connections
IMPORTANT Not all tasks described in this quick start are required to complete the final task, that is, use ladder logic to test a
1769-OB16 output module as described beginning on
page 63 . For example, you do not need a DeviceNet configuration
file to test the module.
We expect that you might attempt to complete additional tasks with your control system by using the publications
listed on
page 12 relating to using a component over a DeviceNet network in a Logix5000 control system. When you use
those publications, some assumptions are made. For example, if you use POINT I/O modules over a DeviceNet network in
a CompactLogix 5370 L3 control system, you must have already created a Logix Designer application project and created
a DeviceNet configuration file.
If you complete all of the tasks described in this chapter, you can easily complete the tasks described in the publications
listed on
page 12 related to using a DeviceNet network.