Rockwell Automation Liqui-Flo Trane Addendum - Manual (Page 35)

Cabinet Servicing 5-5
Step 14. Using an overhead or portable hoist (minimum 1/2 ton rated capacity), attach
a free-fall chain to the 1.5” hole in the support bar. Take up any vertical slack
in the chain.
Step 15. Vertically lift the support bar and the drive 3” to 4”.
a. Rotate the support bar to the right side, towards you, and slip the support
bar/drive assembly out of the cabinet.
Step 16. Move the drive to a horizontal pallet for servicing or shipment. The support
bar and screws do not need to be removed.
Step 17. Reinstall the drive by following steps 16 to 1 in reverse order.
a. During reinstallation, tighten the hardware to the torque values
(+ 10%) shown in table 5.1.
b. Visually inspect the insulation of the wiring and buswork to ensure that it
was not damaged.
c. Refill the drive with coolant.
Step 18. Test the drive for proper operation by following the start-up procedures in
instruction manual D2-3410.