AJA Ki Pro - Manual (Page 21)

Ki Pro v3.2 www.aja.com 21
HDMI formats supported:
• 525i 29.97
• 625i 25
• 720p 50, 720p 59.94
• 1080i 25, 1080i 29.97,
• 1080p 23.98, 1080p 24, 1080p 25, 1080p 29.97
NOTE: When using Ki Pro HDMI connections and attaching it to any HDMI audio or video accessory,
you must use one each of the ferrite beaded HDMI cables, HH-28F-06, between the input and
output ports of the Ki Pro and the HDMI accessory to maintain regulatory compliance.
Analog 2 Channel
Balanced Audio Input
and Output
Four XLRs, 2 female for input and 2 male for output, provide 2
channels of balanced audio. Audio is high-quality 24-bit A/D
input and D/A output at 48kHz. Level adjustments are made via
software and a switch for line-level inputs. Software level
adjustments for analog audio (parameter 4.1) apply to balanced
audio (XLR) using the “Line” setting on the switch. The Mic and
Mic +48 settings offer a lower input level suitable for
microphones and their associated input impedance. Use Mic +48
for microphones with phantom power (condenser mic.), or Mic for microphones without
phantom power (dynamic micrphones).
Analog 2 Channel
Unbalanced Audio
Input and Output
Two RCA connectors provide an unbalanced stereo audio input pair for use with
consumer camcorders, VTR/VCRs and other A/V devices. For output, two RCA connectors
provide an unbalanced stereo audio output pair for driving inexpensive audio
monitoring systems.
9-pin Connector Ki Pro features a 9-pin serial port that may be used with some RS-422
devices.
IMPORTANT: Not all RS-422 devices have been tested with Ki Pro, so AJA cannot definitively say which
devices may or may not communicate as expected with Ki Pro when operated under RS-422
remote control. Refer to the latest Release Notes document for which devices or non-linear
editors have been tested with Ki Pro operating under RS-422 control.
Host (FireWire 800) IEEE 1394b FireWire connector allows for data transfer to or from an Apple
FireWire 800 equipped computer. This connector does not support connection
to any other FireWire devices such as cameras or hard drives.
CTRL/TC (FireWire 400) IEEE 1394a FireWire™ connector for connecting Ki Pro to a camera for timecode
control. This connector does not support data transfer of compressed audio/
video signals nor does it support connection to hard drives.
Ethernet An RJ45 connector provides a 10/100/1000 Ethernet port for connecting Ki Pro
directly to a computer or Ethernet hub or switch for connecting to a LAN. Ki
Pro is compatible with CAT-5 straight-through or cross-over Ethernet cables,
automatically detecting which is used. Once connected and properly
configured, Ki Pro can then be controlled by a web browser on the LAN.