AJA Ki Pro - Manual (Page 31)

Ki Pro v3.2 www.aja.com 31
Attaching the optional Ki Pro Exo-skeleton rod accessory kit is simple:
1. Open the kit box; you’ll find preassembled endplates—these must be disassembled
before you can attached the plates to the Exo-skeleton. Place an endplate from the
kit on the outside of the Exo-skeleton frame, aligning it’s two screw slots with the two
screw holes in the frame.
2. Insert one of the supplied screws from the inside of the frame through the frame hole
and slot. While holding the screw from the inside, place a supplied washer over the
threaded end of the screw and screw one of the supplied knobs over the end of the
screw.
3. Repeat step 2 for each of the 4 knobs, washers and screws.
Once the kit is installed, you can then loosen the rod lock knobs, insert user-supplied
15mm accessory rods, and then mount any desired accessories.
To raise or lower the rods, simply loosen the rod height adjustment knobs (the ones you
installed in step 2), lift the rods to the desired height, and then tighten the knobs once
complete
Figure 14. Exo-skeleton Endplates and Rod Height Adjustment.