AJA Ki Pro - Manual (Page 46)

Ki Pro v3.2 www.aja.com 46
"WARNING Storage Removed" will appear if the media is removed without first
hitting the SLOT button to properly unmount media. In the event this happens,
media immediately re-inserted into the Ki Pro may show clips as "N/A" and
subsequent recordings may not be possible. To resolve this issue, mount the drive
on an Apple computer under Mac OSX, then re-insert the media. If it does not read
properly, you will need to format the media.
"WARNING Backup and Reformat" may appear if media has issues being mounted by
the Ki Pro. As the prompt indicates, it is best to back up the media by copying it to
another drive or disk array and then reformat the media. Some signs that the media
is in a read-only state: even though clips have been recorded to the media, "N/A"
appears in the clip area of the UI, "Loading" appears in the clip area of the UI but
does not eventually load a clip, or hitting the record button with all settings correctly
configured for the Ki Pro does not result in a recording.
"WARNING Media Unformatted" appears when media was inserted that contains no
filesystem recognized by Ki Pro. Ki Pro recognizes HFS+ filesystems; media with
other types of filesystems may appear unformatted to Ki Pro. Unformatted media or
media with other types of filesystems (FAT32, etc.) may be formatted by the usual
means.
"WARNING Change Encode Type" appears because ProResHQ is not supported on
ExpressCard/34. Select another flavor of ProRes (normal, LT or Proxy) before
attempting to record to an ExpressCard/34.
"WARNING Invalid Selection" appears when Ki Pro receives conflicting configuration
requests, such as selecting component in/out "Beta" for HD.
"WARNING Name In Use" appears when an attempt was made to record over a
previously existing clip. This can happen when the take number reaches its
maximum, 999. To resolve it change one of the clip naming parameters to eliminate
the naming conflict.
"WARNING No Video Input" appears when an attempt was made to record but no
video was detected on the input. Check connections and sources to make sure valid
video is being fed to the input selected in 2.1 Video Input.
"WARNING 2 Channel Format" appears when the number of channels selected in 2.3
Audio Channels is eight, but the selected audio input only supports two channels.
Only SDI supports eight channels.
"WARNING Genlock Missing" appears when 6.1 Genlock has been set to INPUT or
Component Y but there is no signal detected on the chosen genlock input.
"WARNING Genlock Mismatch" appears when 6.1 Genlock has been set to INPUT or
Component Y but the signal detected on the selected genlock input is incompatible
with the video format on the selected video input.
"WARNING Non VFR Format" appears when 1.1 Record type is set to VFR (variable
frame rate), but the video to record is not a valid VFR type. This can happen because
the video format on the selected video input doesn't support or isn't carrying VFR
ancillary data, or the video signal generator is enabled in 41.2 VIDEO SG or 1.4 Input
Conversion is enabled.
"WARNING No Clip Name" appears when an attempt was made on a ganged slave
unit to set the clip name to use from a master, but the name was empty. The custom
clip name on the master may be empty.