AJA Ki Pro - Manual (Page 52)

Ki Pro v3.2 www.aja.com 52
NOTE: When entering characters for a custom clip name, you must scroll through all characters
using the Adjust buttons until you reach the end of the name space before the name is
accepted.
19.1 USE CUSTOM CLIP
NAME
This parameter enables or disables whether a custom clip name can be used via menu
parameters 19.1, 19.2, and 19.4, or via the web UI. These are the options:
19.2 CUSTOM CLIP
NAME
This parameter defines a custom clip name. The custom clip name is defined via the front
panel select and adjust up/down arrows. The default name is “CUSTOM”.
19.4 CUSTOM TAKE This parameter defines a custom take. The custom take number is defined via the front
panel select and adjust up/down arrows.
22.1 GANG CLIP NAME This parameter is used when performing gang recording via multiple Ki Pros (refer to
Controlling Multiple Ki Pros later in this manual). If the desire is to have clips named the
same across all Ki Pro ganged units' recordings, then use the "Master Name" selection in
this parameter. If the desire is to have clips named independently on Ki Pro units, then
"Slave Name" should be selected. Selecting "Slave Name" means that the recording will
take its name from the individual Ki Pro's parameters and not accept the value pushed to
the Slave by the Master Ki Pro.
CONFIG menus
When we talk about menus, we discuss the Parameter Number and Name on the top line
of the display and the Parameter Setting(s) possible as shown on the bottom line of the
display; remember, the current setting is what is shown.
OFF (default)
ON Enable defining of custom clip name
Disable defining of custom clip name
variable Using the adjust buttons, enter a custom clip name. Using
the adjust buttons and the top Select button, select the
characters for the name. The adjust buttons scroll through
the choices and the top Select button advances to the next
character. While selecting characters, the character being
changed will flash to show its position. Certain characters
may not be allowed or supported if entered for a clip name.
Examples include: punctuation marks (other than internal
spaces or periods), special characters (like @), and non-
ASCII UTF-8 characters are rejected outright. Note: non-
UTF-8 characters appear in some languages, like Chinese
and Japanese, and are not supported.
Default: CUSTOM
1 to 999
(default = 1) Press ADJUST button up or down to change the TAKE value
from 1 to 999, if a value other than the automatically
generated value is desired.
Master Name (default)
Slave Name Name clips the same across all Ki Pro ganged units
Name clips independently on Ki Pro units