AJA Ki Pro - Manual (Page 59)

Ki Pro v3.2 www.aja.com 59
Figure 20. Down Conversion Illustrations
6.1 GENLOCK This parameter selects source of reference video used to genlock to during playback. Ki
Pro always genlocks to the selected input during capture. These are the options:
8.0 TC IN This parameter selects the source of timecode start from those available. These are the
options:
8.1 TC VALUE This parameter selects the starting hour for timecode when 8.0 is set to TC Value. These
are the options:
8.2 TC TYPE This parameter selects drop frame or non-drop frame timecode. These are the options:
1 6
9
Anamorphic
Letterbox
4
3
16:9 Downconverts To These displays on 4:3
Crop
INPUT
CMP Y
FREERUN (default) Use the currently selected input as the Genlock source
Use component Y as the Genlock source
Free run mode: Ki Pro syncs to its own timebase and is not
locked to an external source
TC VALUE (default)
SDI RP188
LTC
FW400
TIME OF DAY
RS422
Use the value specified in parameter 8.1 TC VALUE
Use the timecode read from the embedded RP188 metadata
in the SDI input
Use timecode from the LTC input connector
FireWire TC value is used (FW400 is presented only if
parameter 35.2 is set to FW Only)
Set TC to “Time of Day” clock (CONFIG parameter 55.6)
RS422 in-point TC value is used for the start value of a
recording (presented only if 35.2 is set to RS422 Only)
00:00:00:00 to 23:00:00:00
(Default: 01:00:00:00) Use the ADJUST buttons to select a timecode hour.
For example: “01:00:00:00”, “02:00:00:00”, etc.