AJA Ki Pro - Manual (Page 68)

Ki Pro v3.2 www.aja.com 68
50.9 USER
AUTHENTICATION
This parameter enables or disables an authentication login requirement when using the
web UI. By default this parameter is set to Disabled.
If you select Login via the front panel interface and then you attempt to use the web UI
interface, you will be asked for a login password. The web browser will present the login
screen requesting that a password be entered before you can access any other parameter
or configuration screen.
The password is initially set to the default value: password
If you select Login for the User Authentication parameter via the web UI, you may enter a
user selected password. As long as the menu parameter is not changed to Disabled, the
password requirement will remain in effect. Any time the web UI is accessed, the login
password will be requested before additional access to any other web UI parameter or
configuration screen will be granted. If you enter a user selected password, be aware that
this password will be retained and you will need to remember the password. If the user
entered password is forgotten, you may clear it by performing a Hard Factory Reset. Note
that a standard Factory Reset does not clear the user entered password. To perform a
Hard Factory Reset, enter the 99.0 Factory Reset parameter, and unlike a typical Factory
Reset where only the ADJUST (up) button is held for 2 seconds, hold both the ADJUST
(up) and the ADJUST (down) buttons simultaneously for 2 seconds.
NOTE: If authentication is used, it provides a minimum security safeguard against unauthorized use
of the Ki Pro in a networked environment. You should not consider it a substitute for proper
network security measures.
53.0 802.11 AVAILABLE This parameter shows all available 802.11 wireless networks detected by Ki Pro. Choosing
a network selects it for parameter 53.2.
NOTE: Security details for any selected wireless network must be defined by the related parameters
53.3 through 53.5.
53.1 802.11 CONTROL This parameter determines whether Ki Pro can be controlled remotely from a wireless
browser.
DISABLED (default)
LOGIN
Disables the requirement for a login password when
accessing the device via the web UI.
Login is required via the web UI before changes can be made
to the Ki Pro configuration.
information display Choosing this parameter allows you to view 802.11 wireless
networks within signal range of Ki Pro. The Adjust buttons
allow you to scroll up or down to view those available. If
you find one that you want to connect
Ki Pro to, then select it via the Adjust buttons and it will then
transfer to parameter 53.2 (802.11 NETWORK) as the
selected wireless network.
DISABLED (default)
ENABLED Disable wireless control of Ki Pro
Enable wireless 802.11 control of Ki Pro