AJA Ki Pro - Manual (Page 72)

Ki Pro v3.2 www.aja.com 72
70.2 DISPLAY
INTENSITY
This parameter determines the brightness of the alphanumeric VFD display and front
panel backlit buttons. A dimmer display uses less power.
70.3 FAN SPEED This parameter determines the speed of Ki Pro’s internal cooling fan. In some
environments where audio recording is occurring close to the Ki Pro unit, it may be
desirable to set the fan speed to “QUIET RECORD” for optimum quiet operation.
80.1 SERIAL NUMBER This parameter displays this Ki Pro’s unique serial number.
80.2 SW VERSION This parameter displays Ki Pro’s software version level.
91.1 RECALL PRESET This parameter recalls the Ki Pro to a previously saved preset configuration stored using
parameter 92.1. Use the ADJUST buttons to set the number of the Preset register you
wish to recall. To recall, press the SELECT up (^) button, and then press the ADJUST up (^)
button. The message [COMPLETE] is displayed after a successful recall.
92.1 STORE PRESET This parameter saves a preset configuration to the selected storage register. Use the
ADJUST buttons to set the number of the Preset register. To store, press the SELECT up (^)
button, and then press the ADJUST up (^) button. The message [COMPLETE] is displayed
after a successful store.
99.1 FACTORY RESET Selecting this parameter and then pressing the ADJUST (up) button for 2 seconds recalls
Ki Pro’s factory default settings.
Recalling factory defaults does not affect these network settings: IP Config, IP Address,
Subnet Mask, Default Gateway, System Name, 802.11 settings, or Date and Time. To clear
network settings and recall factory defaults, hold down both the Adjust (up) and Adjust
(down) buttons at the same time.
NOTE: To set a single parameter to its factory default value, go to that parameter and hold down
both the Adjust (up) and Adjust (down) buttons at the same time.
variable Using the adjust buttons, you can dim or brighten the
alphanumeric display and activity indicator LEDs in steps
from 1 (dim) to 8 (brightest).
Default: 6
NORMAL (default)
QUIET RECORD
QUIET AUTO
NORMAL AUTO
Fan runs at normal fixed speed for optimum cooling.
Fan runs at a fixed slower speed for optimum quiet.
Fan runs at normal speed until recording begins, then the fan
ramps down to a slower speed for optimum quiet.
Fan runs at variable speeds for optimum cooling.
Caution!
Selecting this parameter and recalling factory defaults will overwrite the current
settings (with the exception of network settings, which are retained).