Advanced features, Controlling multiple ki pros, Gang recording – AJA Ki Pro User Manual

Page 95: Controlling multiple ki pros gang recording

Advertising
background image

Ki Pro v3.2

www.aja.com

95

Figure 39. Ki Pro iPhone Interface, Transport Screen

Advanced Features

A few notes and instructions about selected features may help you get more value out of
your Ki Pro. The following topics expand on the information presented earlier in this
chapter.

Controlling Multiple
Ki Pros

From the Status screen and the other top five screens of the Menu, you can see at-a-
glance all of the Ki Pro systems that are present on the same local LAN. Their system
names are shown in the Network panel on the right side of the screen. Click a system
name to switch the browser to the Status screen of that Ki Pro or Ki Pro Mini system.

NOTE:

The Ki Pro you control may be running a different software version so screens may look
different. As a rule, it’s wise to have all your Ki Pro devices running the most current software
and the same version. Also, you must have a properly configured default gateway to see the Ki
Pros.

If the Default Gateway (parameter 50.4) is not configured properly, other Ki Pros will not
be listed. If the display shows “No Ki Pros found” then check the gateway setting.

Also, if the Default Gateway (parameter 50.4) is not configured properly, other Ki Pros will
not be visible here. If it displays “No Ki Pros found” then check the gateway setting.

Gang Recording

Multiple Ki Pro units can be used in unison to produce recordings via the Gang Control
feature, beginning with Ki Pro version 2.0 firmware. This feature is only available via the
web UI when Ki Pro units have IP addresses configured under a common network and
subnet mask and are connected via their LAN connections to an ethernet switch or hub
to a host computer. AJA recommends that all Ki Pro units in a gang use the same
firmware version

Landscape View

Advertising