Baumfolder BAUM20: Ifold Service Manual - Manual (Page 11)

16.
Cleanup wiring and reinstall all wire channel covers that were removed.
17.
Replace DCT
500 sof
tware chip, shown in Figure 9. Carefully do this by using a small screw driver and lifting the
chip at both ends and out of the U6 socket. Do not handle the chip by the legs, only by the sides of the chip. Note the orientation of the chip notch, the new chip must be installed in the same direction. Care must be taken not to touch the legs of the chip. Carefully install new chip into the U6 socket.
Figure 9
DCT500 B
oard
Orientation Stripe
Ribbon Cable
X27 Connector
Run/Maintenance jumper
Software chip
Notch end
9
Page 9 of 45 TP10497