Baumfolder BAUM20: Ifold Service Manual User Manual
Page 7
11.
T
he comm
unication board will sit on the right side of din rail that sits above the transformer, as shown in Figure 5.
Run the communication cable to the top of the communication board and will wire into the two rows of terminals.
Add an extra 2” to 3” of cable, and then cut cable to that length. Strip back 4” of cable jacket and shielding to expose conductors. Cut pink, brown & green conductors 1” shorter than the other three conductors. Strip
approximately 5/16” of wire insulation from each conductor. Wire communication cable into the communication
board terminal block as shown in figure 6.
Figure 5
Communication Cable
T
erminal Block
Din Rail
Cable
Orientation Stripe
Ribbon Cable
Communication Board
DCT500 B
oard
5
Page 5 of 45
TP10497