Baumfolder BAUM20: Ifold Service Manual User Manual
Page 4
4.
Install mounting arm into display mount.
5.
Mount computer and enclosure onto mounting arm as shown in figure 3.
6.
Remove Bottom cover plate from I-fold computer enclosure, to expose computer’s connectors, see Figure 1.
7.
Install power cable FK201500 into computers power socket. Install communication cable FK2001501 into computer receptacle “COM 2”, see Figure 2.
8.
Run both the power and communication cable through a cable strain relief located in a plate on the back side of the
computer’s enclosure, until both cables have a 3” to 4” service loop on the cable between the connectors and the strain relief’s. T
ight
en outer strain relief nut to hold cables securely, see Figure 3.
9.
Run both power and communication cable up into the hole of the enclosure mounting bracket and down through
the goose neck mounting arm tube and pull cables out the bottom of the mounting block, as shown in Figure 3.
Figure 2
2
Communication Cable
Power Cable
Page 2 of 45
TP10497