I-fold electrical installation – Baumfolder BAUM20: Ifold Service Manual User Manual
Page 3
Advertising
I-FOLD ELECTRICAL INSTALLATION
1.
WARNING: Power MUST
BE DISCONNECT
ED from the machine before starting this procedure.
2.
Remove the back feeder, parallel & register guards.
3.
Install I-fold display mount (See Assy. Drawing FK2001426) onto register frame as shown in I-fold display mounting
location (See Page 33). Note: Before tightening the (4) socket head screws, locate display mount so that a gap
between the top of the register frame and the display mount is at maximum clearance, so that the register guard can be re-installed.
Figure 1
COM 2
Power Switch
Power Socket
1
Page 1 of 45
TP10497
Advertising