Bendix Commercial Vehicle Systems EC-15 ANTILOCK CONTROLLER ASSY 4/08 - Manual (Page 24)

24
TURN IGNITION OFF AND INSPECT
APPROPRIATE AXLE AND WHEEL FOR
PRESENCE OF AN EXCITER OR TONE
RING AND SPEED SENSOR. CHECK THE
SENSOR “GAP” (DISTANCE BETWEEN
SPEED SENSOR AND EXCITER RING) AND
BEARING END PLAY. RE-ADJUST AS
NECESSARY.
YES
HOLD A MAGNET ON RESET
OF EC-15
™ CONTROLLER AND
NOTE LEDS
NO
RUN VEHICLE AT 10 MPH OR MORE
FOR 30 SECONDS OR MORE. TURN
OFF IGNITION
REPLACE EC-15 ™
CONTROLLER
ARE ALL LEDS ILLUMINATED?
REMOVE MAGNET
REPEAT “INITIAL START-UP
PROCEDURE”
TROUBLESHOOTING
SECTION IX - TESTING FOR FALSE INDICATION CAUSED BY WHEEL SPEED COMPONENTS
START HERE
BW1663 © 2004 Bendix Commercial Vehicle Systems LLC All rights reserved. 5/2004 Printed in U.S.A.