Brandmotion 1013-9550 - Manual (Page 6)

INSTALLATION
INSTRUCTIONS
9550 Instructions 1-8-13.doc Page 6 of 13
Figure 23
C. Insert pink wire from the supplied NAV Harness
into the larger connector of the Denali Jumper
Harness by using Delphi Terminal Tool 12094429
or a small flat blade screwdriver to press the
terminal fully into the connector. (Figure 24)
Figure 24
D. Insert the pink wire from Connector C12/ X12
into the other cavity in the Denali Jumper
Harness. (Figure 25)
Figure 25
E. Slide gray TPA over to lock wires into place.
F. Snap the supplied Denali Jumper Harness into
other half of Denali Jumper on supplied NAV
Harness. (Figure 26). Then, connect pink wire of
Denali Jumper Harness to cavity 7 of C12/ X12
connector (where pink wire was removed).
Figure 26
30. Re-insert TPA and plug C12/ X12 Connector into M-
BEC. (Figure 14) Proceed to Step 32.
31. If all M-BEC connections are secure and no
fuses are blown and reverse still is not
present, reverse must be located in the under dash
BCM left of the steering wheel. (Figures 13 & 27)
A. Cut the connector off the green Reverse (+) wire
of supplied NAV Harness and splice to wire in brown
BCM X5 Connector Cavity 7. (Figures 13 & 27)
Figure 27
B. Cut the terminal off the pink ignition (+) wire of
supplied NAV Harness and splice to wire in brown
BCM X5 Connector Cavity 13. (Figures 13 & 27)
32. Locate Ground Ring Terminal on black wire of
supplied NAV Harness and attach at the lower knee
bolster stud using supplied Ground Nut and a 10mm
socket. Tighten to 4 N·m (36 lb in). (Figure 28)