Brandmotion 9002-8530 - Manual (Page 2)

INSTALLATION
INSTRUCTIONS
8530 Instructions 4-25-13.doc Page 2 of 4
Step 3: Use a Center Punch to mark the centers of
the required three holes and drill three pilot holes
using a 1/8” drill bit. NOTE: If your vehicle has a
liftgate panel/trunk trim cover, it must be removed.
Step 4: Drill two 5/16” holes for the camera
mounting bolts and one 5/8” hole for the camera
harness.
Step 5 (if necessary): Using a 5/8” drill bit, drill an
opening in the trunk or liftgate for the head of the
Camera Harness to pass through.
Step 6: Use a Cotton Swab to apply supplied Z-tec
Corrosion Inhibitor to any holes you drilled and
allow to dry.
Step 7: Insert Camera Harness head through the
backside of the hole so that the gray connector end
of the Camera Harness is inside the trunk or
liftgate. (RECOMMENDED: Protect Camera Harness
with a rubber grommet or by applying a small
amount of silicone caulk to the area that comes
into contact with the metal.)
Step 8: Route head of Camera Harness through the
pass-through you made with the Template.
Step 9: Use a Phillips Screwdriver to remove the
two screws provided in the Camera to secure the
head of the Camera Harness onto the Camera.
Step 10: Preload the screws into the Camera
Harness connector.
Step 11: Align the Camera Harness head so the
key lines up with the slot in the camera, and plug
in the connector. Snug the supplied screws with a
Phillips Screwdriver to create a watertight seal but
do not over tighten.
Step 12: Mount Camera using supplied
hardware. Insert the supplied rubber Well Nuts
into the two outer Camera Mount holes and use a
Phillips Screwdriver to thread the supplied Bolts in
but do not tighten them down just yet.