Brandmotion 9002-8530 - Manual (Page 4)

INSTALLATION
INSTRUCTIONS
8530 Instructions 4-25-13.doc Page 4 of 4
Step 20: Plug the white 16-pin radio connector
into the female end of supplied Jumper Harness.
Step 21: Plug the male 16-pin connector of
supplied Jumper Harness into the radio.
Step 22: Route supplied Chassis Harness under
carpet to center console area and connect it to the
black 6-pin connector on the supplied Jumper
Harness. CAUTION: Keep harness away from
accelerator, brake pedal, and parking brake
assembly.
Step 18: Coil any excess Chassis Harness and
secure it and the Jumper Harness to existing
vehicle wiring with supplied Wire Ties.
Step 19: Reinstall radio display.
Step 20: Test system. Close trunk or liftgate and
clear all removed items from around the vehicle
before starting the vehicle. Next, shift into Reverse
and check radio display for the camera image.
Step 23: Adjust camera aim. With the aid of an
assistant, position camera to achieve desired view.
Using a Phillips Screwdriver, tighten Camera Mount
bolts.
Step 24: Reassemble vehicle. Follow your
disassembly steps in reverse order, taking care not
to bind the harness wiring when reinstalling trim.
Chart B: Supplied Pinout Reference
PIN
#
FUNCTION
CAMERA
HARNESS
COLOR
CHASSIS
HARNESS
COLOR
1 Video (+) Yellow White
2 Shield White Blue
3 Reverse Blue Green
4 Video (–) Brown Brown
5 Ground Black Black
6 Ignition 12v + Red Red
PIN
#
FUNCTION
JUMPER
HARNESS
COLOR
7 Ignition 12v + Red
8 Ground Black
15 Video (+) White
16 Video (–) Brown