Brandmotion 9002-8530 - Manual (Page 3)

INSTALLATION
INSTRUCTIONS
8530 Instructions 4-25-13.doc Page 3 of 4
Step 13: Connect Camera Harness to gray
connector end of supplied Chassis Harness.
Step 14: Secure Camera Harness to factory wiring
using supplied Wire Tires.
Step 15: Route Camera and/ or Chassis Harness
along existing wiring and secure using supplied
Wire Ties. IMPORTANT: Ensure harnesses move
freely with the trunk or liftgate.
Step 16: Route Chassis Harness forward. It
may be necessary to remove sill plates, pillar
covers, seat bottoms, side panels, etc. Use a plastic
trim removal tool to avoid damage to trim pieces.
In some cases, seatbelt bolts at the bottom of the
pillars must be removed. (CAUTION: Any bolts
removed for safety devices must be retightened to
manufacturer’s specified torque specifications.)
Step 17: Use supplied Wire Ties to secure Chassis
Harness to existing vehicle wiring.
Step 18: Use a Plastic Trim Removal Tool, 10mm
Socket, and Phillips Screwdriver to remove garnish
and fasteners securing the radio display.
Step 19: Remove the radio and disconnect the
smaller white 16-pin connector.