Metrohm 753 Suppressor Module - Manual (Page 18)

2.4 Connection to the 732/733 IC system
753 Suppressor Module / 8.753.1003 Instructions for Use
15
2.4 Connection to the 732/733 IC system
2.4.1 Electrical connection
In order to allow remote operation of the suppressor and pump via the
732 IC Detector, connection 17 17 of the 753 Suppressor Module must be
connected to the "Remote" connection of the 732 IC Detector by means
of the 6.2143.210 cable (available as an option) according to Fig. 8.
Both switches 22 and 66 <REMOTE> on the front of the 753 Suppressor
Module must additionally be set to "ON" to permit remote operation.
753
Fig. 8: Connection 753 Suppressor Module –
732/733 IC system
2.4.2 Connection of the suppressor block
The 1.753.0100 suppressor block must first be inserted in the 733 IC
Separation Center and connected to the 753 Suppressor Module. The
inlet and outlet capillaries mounted on the suppressor are then con-
nected up. Proceed as follows:
6.2143.210
Cable of
suppressor block