E-flite Mini Ultra Stick ARF - Manual (Page 16)

Note: This section covers the installation of an
inrunner motor and gearbox. Refer back to
Page 13 for outrunner installation.
 1. It may be necessary to attach motor adapters
or other accessories to your particular motor
at this time.
Note: Use the instructions provided with the
motor to install any accessories. Follow the
instructions provided with the gearbox for
some helpful hints for installing the motor.
When installing your motor into the E-flite
gearbox, it is very important that the gear
mesh is set correctly and is smooth with no
binding. The E-flite gearbox features adjustable
slotted mounting holes to ensure your gear
mesh is correct. Remember, if the gear mesh
is too loose or too tight it may strip the gears.
To extend the life of your gearbox, we also
recommend using a small amount of grease,
such as lithium grease, on the spur gear.
Inrunner Motor Installation
Required Parts
• Fuselage
• Brushless motor
• Brushless speed control
• #2 x 8mm screw (3)
• 4-40 x 3/8" socket head screw (4)
• EFLM1916 Firewall Stick Mount (included)
• EFLM1900 Pinion Gear, 10T 0.4 Module
6mm w/2mm ID (included with
E-flite™ motor)
• EFLM240 400 Gearbox, 6.5:1 0.5 Module
w/ 2 Pinions (required to purchase)
• EFLP1170 11x7 Slow Flyer Propeller
• EFLA 270 Spinner, 1 3
/
4
" Red (optional)
or
• EFLA204 Micro Rubber Spinner (optional)
Required Tools and Adhesives
• Hex wrench: 3/32"
• Nut driver: 5.5mm
• Screwdriver, #0 Phillips
• Medium CA
• Threadlock
16