E-flite Jenny JN-4 Slow Flyer 250 ARF - Manual (Page 16)

1 E-flite Jenny JN-4 Slow Flyer ARF Assembly Manual
Wing Installation
Required Parts
• Wing (top and bottom) • Outer strut (2)
• Inner strut (front) (2) • Inner strut (rear) (2)
• 2mm x 4mm sheet metal screw (8)
Required Tools and Adhesives
• Phillips screwdriver • Foam-safe CA
• Hobby knife • Felt-tipped pen
 1. Position the bottom wing on the fuselage. Line the
holes in the wing up with the holes in the cross supports
in the fuselage. Use four 2mm x 4mm sheet metal screws
to attach the bottom wing to the fuselage. Do not over-
tighten the screws and damage the wing.
 2. Slide the outer struts through the bottom wing. Note
the direction of the strut. The rear has an angle, while the
front is straight.
 3. Use a hobby knife to make two small holes in the
mounting points of the cabane struts. Make the hole in
the rear mounting pads at this time.