E-flite Jenny JN-4 Slow Flyer 250 ARF - Manual (Page 17)

17 E-flite Jenny JN-4 Slow Flyer ARF Assembly Manual
 4. Use a felt-tipped pen to mark the holes made in the
previous step. This will help in sighting the holes through
the wing.
 5. Attach the rear of the top wing using two 2mm x
4mm sheet metal screws. Mark the locations for the front
screws through the wing on the mounting pads. The
cabane struts may require some adjustments to line up
with the holes in the wing.
 6. Repeat the procedure from Steps 3 and 4 to make the
holes on the mounting pads at the front of the cabane
struts. Attach the wing using a total of four 2mm x 4mm
sheet metal screws.
Note: The alignment of the wings is very important for
smooth, predictable flight. Take your time during the next
few steps to ensure you do not build a warp into the
wing platform at any time.