E-flite Jenny JN-4 Slow Flyer 250 ARF - Manual (Page 18)

18 E-flite Jenny JN-4 Slow Flyer ARF Assembly Manual
 7. Apply foam-safe CA to the strut where it will come
in contact with the bottom wing. Push the strut tight
against the wing.
 8. Apply foam-safe CA to the ends of the struts where
they come in contact with the top wing. Slide the struts
into position and hold the strut while the CA cures.
  9. Locate the inner struts. Select a front and rear strut.
The rear strut has a greater angle than the front as shown
in the photo below.
  10. Position the inner struts between the top and bottom
wing. Use foam-safe CA to glue the struts to the wings.
 11. Repeat Steps 9 and 10 to install the remaining
inner struts.