Emergency stop switches, Autogrip and multi core shafts and upper idler, A. upper front rewind shaft – GBC 64C User Manual
Page 16: B. upper unwind shaft, C. upper idler, Autogrip
SPIRE II Series – Installation and Operating Instructions
Page 5-2
e
merGency
s
top
s
WItches
Figure 5. Emergency Stop Switch near Operator Panel.
Four Emergency Stop (also referred to as E-Stop)
Switches are available on the Laminator. The
Emergency Stop Switches are located on all four
upper corners of the machine.
To engage the Emergency Stop Switch (A), press any
one down to stop the roller movement.
To disengage the Emergency Stop Switch, turn it
clockwise after the emergency condition has been
resolved.
Figure 6. Emergency Stop Switch on back of the laminator.
autoGrIp
and
m
ultI
c
ore
s
haFts
and
u
pper
I
dler
The 3 inch AUTOGRIP and Multi Core Shafts can
be used in all positions as supply or rewind shafts.
Rulers in inches and centimeters are incorporated
into each AUTOGRIP Shaft.
Figure 7. Upper Front Rewind and Upper Unwind Shafts.
a. u
pper
F
ront
r
eWInd
s
haFt
The Upper Front Rewind Shaft is used to rewind
release liners or finished media.
B. u
pper
u
nWInd
s
haFt
The Upper Unwind Shaft is used to hold film or
media that will be used for the job, and to apply
brake tension.
c. u
pper
I
dler
The Upper Idler guides the upper lamination onto the
Top Main Roller, ensuring a constant amount of wrap
on the Top Main Roller.