GBC 64C - Manual (Page 21)

Page 5-7
SPIRE II Series – Installation and Operating Instructions
r
emovInG the
F
eed
t
aBle
WARNING: Removing the Feed Table exposes
moving parts. This means you can be harmed when
the Feed Table is removed. Make sure to replace the
Feed Table when film loading is completed.
The Feed Table must be removed to load films.
To remove the Feed Table:
1. Remove the Pressure Plate.
Refer to the “Removing the Pressure Plate”
section.
2. Under the Feed Table, at each end, press the
Release button of the Table Interlock.
Figure 20. Feed Table Interlock Release button.
3. Grasp the front edge of the Feed Table and lift
outward and upward to release the front Feed
Table pins from the Feed Table.
Figure 21. Raise the Front of the Table.
4. Grasp the support on the bottom of the table and
lift the Feed Table out of the machine.
Figure 22. Pull Feed Table From Pins.
5. To replace the Feed Table, reverse the steps.
6. Be sure to push the Table Interlocks towards the
Side Frames to secure the Feed Table.
Figure 23. Table Interlock in the locked position.
Note: When the Table Interlocks are unlocked, the
rollers will rotate at 3 ft. (1 meter) per min. if the
Footswitch is pressed.
7. Replace the Pressure Plate.