GBC 64C - Manual (Page 23)

Page 5-9
SPIRE II Series – Installation and Operating Instructions
c
ontrol
p
anel
The Control Panel is located on the right side of the
machine and controls all operations of the machine.
The top portion of the control panel shows the
webbing configuration for the laminator.
A B C
D
E
Figure 25. Control Panel.
a. stop
Press to stop the rollers. The LEDs above the buttons
illuminate to indicate which function is selected.
B. run
Press to run the rollers at the selected speed.
c. rev
When this button is pressed and held, the rollers will
rotate at 3 ft. (1 meter) per min. in reverse. Once the
REV button is released, the Rollers will stop rotating
in reverse.
d. PRESSURE
LEDs illuminate to indicate the amount of pressure
between the Main Rollers.
e. s
peed
c
ontrol
k
noB
Turn to increase or decrease the roller speed.
Rotate clockwise to increase speed. Rotate
counterclockwise to reduce speed. The range is 1
to 10 and the maximum speed is 20 ft. (6 meters)
per minute. The display indicates the set speed. The
display flashes when using the Footswitch to indicate
an override of the Photo Safety Sensor and the
Interlock on the Feed Table. Refer to the “B. Photo
Safety Sensor” and “Feed Table” sections.