GBC 64C - Manual (Page 18)

SPIRE II Series – Installation and Operating Instructions
Page 5-4
F
ootsWItch
Figure 10. Footswitch.
The Footswitch allows you to start and stop the
laminator while handling the item to be laminated.
Press the Footswitch to run the laminator and release
it to stop the laminator.
When the Footswitch is used and the Photo Safety
Sensor is blocked, the speed of the laminator drops
to 3 ft. (1 meter) per min. When the Feed Table is
removed, the rollers will rotate if the Footswitch is
pressed. The machine will run at 3 ft. (1 meter) per
min.
l
oWer
s
haFts
a
nd
I
dler
B
ar
Figure 11. Lower Multi Core Supply Shaft and Idler Bar.
a. l
oWer
m
ultI
c
ore
s
upply
s
haFt
The Lower Multi Core Supply Shaft is used to hold
film or media to be used for the job and to apply
brake tension.
B. l
oWer
I
dler
B
ar
The Lower Idler guides the lower film or media onto
the Bottom Main Roller, ensuring a constant amount
of wrap is on the Bottom Main Roller.
m
ultI
c
ore
a
daptors
Multi Core Adaptors grip the media supply tube. The
Multi Core Adaptors accommodate 2 through 3 inch
diameter cores.
Figure 12. Multi Core Adaptor on a Shaft.
The Multi Core Adaptors are secured to the shaft
with two hex head screws. Using an Allen wrench,
loosen the screws and slide the Multi Core Adaptor
along the shaft to accommodate the core, and then
tighten the screws.
r
ear
t
aBle and
o
ptIonal
I
dler
Figure 13. Rear Table and optional Idler.
a. r
ear
t
aBle
The Rear Table supports the web as it exits the
machine.
B. o
ptIonal
r
ear
t
aBle
I
dler
The optional Rear Table Idler is part of the Rear Table
and assists the web as it exits the laminator.