GBC 64C - Manual (Page 31)

Page 6-7
SPIRE II Series – Installation and Operating Instructions
(2)
(2)
(1)
Printed media or mount adhesive
Rewinder
Main
Roller
PSA Laminate
Idler
Feed
Table
Idler
Main
Roller
(1)
Figure 40. Cutting film from the laminator diagram.
5. Carefully cut the remaining top film web and
release liner between the idler bar and Main
Roller (2).
6. Carefully cut the film web between the lower film
supply and the idler bar (3).
CAUTION: Be careful to not cut the rollers.
7. Adjust the gap of the Rollers.
8. Carefully grab the web (top and bottom film),
from the front operating position and pull
towards you.
Printed media or mount adhesive
Rewinder
Main
Roller
PSA Laminate
Idler
Feed
Table
Idler
Main
Roller
Pull
web
Figure 41. Pulling remaining web from the laminator
diagram.
9. Do not allow the adhesive side of the film to
contact the Main Rollers.