GBC MP2500ix - Manual (Page 22)

22
PUNCHING
Binding Style Punching Pattern
Die Set
Label
Plastic Binding (PB)
Plastic Color Coil (C4)
Twin Loop Wire (W3)
Twin Loop Wire (W3)
Twin Loop Wire (W2)
Twin Loop Wire (W2)
VeloBind (VB)
SureBind (SB)
3, 5 or 7 Hole Binding 11"
2 or 4 Hole Binding A4
2 Hole Binding, 11"
Cerlox (Plastic Comb)
4:1 GBC (4 holes per inch, 0.2475"
center-to -center hole spacing)
3:1 (3 square holes per inch)
3:1 (3 round holes per inch)
2:1 (2 square holes per inch)
2:1 (2 round holes per inch)
1 hole per inch
Approximately 1 hole per inch
3 holes across bound edge of document,
11" paper
4 holes across bound edge of
document, A4 paper
2 holes across bound edge of document, 8
1/2" paper, medical or legal clip board style
PB 19/21
4:1 GBC
3:1
3:1
2:1
2:1
VB
SB
2-4/3-5-7
2-4/3-5-7
2-4/3-5-7
TABLE 1
The MP2500iX uses a variety of easily
interchangeable die sets that allow you to
bind documents using many different
binding styles. By selecting the
appropriate die set, you can use your
MP2500iX to punch documents in any of
the binding styles indicated in Table 1.
Please note that each punching style
listed above requires a separate die set
for the MP2500iX. with the single
exception of the 2-4/3-5-7 die set which
handles Loose Leaf Binding styles in one
die set.
IMPORTANT: A decal on the handle of
each interchangeable die set indicates the
punching pattern. When reading the
Operating Instructions, please note the
special instructions for the correct
punching pattern die set that you have
installed in your MP2500iX.