GBC 62fm - Manual (Page 13)

5-1
Operating Instructions
62FM L
AMINATOR
P
OSITIONING
I
NDICATOR
Positioning... appears in place of the ready/wait
indicator any time the main rollers are traveling in an
upward or downward motion.
M
ASTER
D
IAL
Increases (+) or decreases (-) the numeric value for
the selected setting when turned. Press and hold the
dial to display actual temperature of top and bottom
main rollers.
T
OP
T
EMP
.
When pressed, permits increasing or decreasing of
the top temperature by turning the
Master Dial
and is indicated on the control panel display. Range
is room temperature up to 300 °F (150 °C).
B
OTTOM
T
EMP
.
When pressed, permits increasing or decreasing
of the bottom temperature by turning the
MASTER
DIAL and is indicated on the control panel
display. Range is room temperature up to 300 °F
(150 °C).
P
RESS
/R
ELEASE
When pressed, raises the upper main roller
overriding the pull roller handle setting. When
pressed again, reverts to current pull roller handle
setting.
C
OOLING
When pressed, turns on the cooling fans. When
pressed again, turns off the cooling fans.
J
OB
When pressed, permits scrolling of job numbers by
turning the
MASTER DIAL and is indicated on the
control panel display. Range is 1 to 10. Job 10 is
reserved for running AccuShield material.
To store parameters for a particular job number,
select the desired job number location, enter the
upper and lower temperatures and speed, then press
Job.
C
ONTROL
P
ANEL
Fig. 5-1. Control Panel.
C
ONTROL
P
ANEL
D
ISPLAY
Illuminates when the laminator is plugged in and
POWER I/O is in the on, (I), position. Displays
settings for top heater, bottom heater, speed, job,
mode, and ready/wait status and roller position
indicator.
R
OLLER
P
OSITION
I
NDICATOR
Displays the current main roller position. In Fig. 5-1,
the roller is shown in the
Release position. Refer to
Roller Handle for more information.
R
EADY
/W
AIT
I
NDICATOR
READY appears when actual temperature is equal
to (+/- 5) set temperature.
WAIT appears when
actual temperature is lower or higher than the set
temperature.
5. C
ONTROL
G
UIDE
Top Temp.
Bottom Temp.
Rev. Stop Run
Cooling Press/Release
Job
Speed
TOP>032˚F
BOT>032˚F
RELEASE
WAIT
SPEED>03
JOB>01