GBC 62fm - Manual (Page 16)

Operating Instructions
5-4
62FM L
AMINATOR
Emergency stop
button
Control panel
Safety shield
Safety
shield
interlock
latch
Heat rollers
Foot switch
Tension knobs
Roller handle
Tension knob
Idler bar
Feed table
Film shaft
Rewind
Fig. 5-4. 62FM Laminator Identification.
F
EATURES
P
OWER
I/O (O
N
/O
FF
)
Located at the back left of the machine applies
power to the laminator. The control panel display will
illuminate when switch is rotated to the
“l” position.
The off position, marked “O”, removes power from
the laminator.
E
MERGENCY
S
TOP
Two emergency stop buttons exist on the laminator.
One on each side of the upper cabinet. To engage,
press either push button, roller movement is
stopped. To disengage, turn the push button
clockwise once the emergency condition has been
resolved.
S
AFETY
S
HIELD
Prevents entanglement, entrapment and inadvertent
contact with the heat rollers.
The laminator will
operate in the continuous mode only when
the safety shield is located in the fully locked
position. The foot switch operates the rollers at 3
fpm (0.9 mpm). The safety shield is removed only
when you load films or clear jams.
To remove the safety shield, unlock the safety shield
interlock latch and lift the safety shield up and away
from the safety shield mounting pins.
This shield must also be used on the rear of the
laminator when the laminator is operated from the
rear.