GBC 62fm - Manual (Page 15)

5-3
Operating Instructions
62FM L
AMINATOR
R
EAR
C
ONTROL
S
WITCH
This switch enables the operator to run jobs from the
rear operating position of the laminator when rear
controls are enabled.
Fig. 5-3. Rear Control Switch.
REVERSE: In this position, the rollers turn from the
front operating position towards the rear operating
position.
STOP: Stops the movement of the rollers.
RUN: In this position, the rollers turn from the rear
operating position towards the front operating
position.
E
NABLE
R
EAR
C
ONTROL
S
WITCH
To enable the rear control switch, press and hold
Job until you hear a beep, approximately 3 seconds.
REAR CONTROL replaces READY/WAIT on the
control panel display.
D
ISABLE
R
EAR
C
ONTROL
S
WITCH
Press and hold Job again to disable the rear control
switch.
F
OOT
SW E
NABLE
In this mode permits operation using the foot switch.
To enable the foot switch, press and hold the
STOP
button for three seconds. Repeat this process to
disable it. Refer to Foot switch for operation.
Rear
control
switch