GBC 62fm - Manual (Page 26)

Operating Instructions
6
62FM L
AMINATOR
Reference one of the loading bottom material
procedures.
B
OTTOM
PSA M
OUNT
F
ILM
This procedure describes how to load a roll of
mount adhesive using the lower unwind position for
decaling. At this point you should have an upper roll
of PSA film loaded onto the laminator.
Fig. 6-10. Loading Bottom PSA Film Without Liner.
Fig. 6-11. Loading Bottom PSA Film With Liner.
Ensure no brake tension is applied to the film
shaft.
Pull the lower roll of film around the lower idler
bar and towards the lower rewind.
Place one piece of masking tape in the center of
the film and secure to the rewind tube.
9.
1.
2.
3.
Make two full wraps around the rewind tube,
then carefully score the laminate without cutting
the release liner.
Adhere the lower PSA film to the loaded upper
roll of film by pulling the film straight up towards
the main rollers.
Reference Threading Card Procedure next.
L
OADING
M
OUNT
A
DHESIVE
T
OP
M
OUNT
A
DHESIVE
This procedure describes how to load a roll of mount
adhesive using the upper position for pre-coating.
Fig. 6-12. Loading Mount Adhesive for Pre-Coating a
Board.
Turn the Power I/O to ON (I).
If the laminator is already hot, turn it to the OFF
(O) position and allow the unit to cool. Once
cool, turn the laminator back on.
Ensure no brake tension is applied to the film
shaft.
Remove the safety shield.
Set the roll of mount adhesive in the upper rear
unwind/rewind position.
Pull the mount adhesive over the upper idler and
upper main roller allowing the material to rest on
the top of the feed table.
Reference Threading Card Procedure next.
4.
5.
5.
1.
2.
3.
4.
5.
5.