GBC 62fm - Manual (Page 22)

Operating Instructions
2
62FM L
AMINATOR
S
TANDBY
M
ODE
The 62FM automatically goes to standby mode
after 3 hours of inactivity. At this time, the laminator
beeps and the heat roller temperature is lowered to
180 °F (80 °C), if they were on.
STAND BY blinks on
the LCD. After another hour of inactivity, the heat is
turned off.
POWER-OFF blinks on the LCD.
To take the laminator out of standby mode, press the
Run button. If the heat was lowered or turned off,
you will have to wait until
READY is displayed on the
control panel.
IMPORTANT: Whenever the laminator will be idle for
an hour or more, press the
Press/Release button .
S
ETTING
J
OBS
I
NTO
M
EMORY
Job settings can be saved into memory for easy
retrieval later.
To save a job into memory:
Press the Job button and select a job number
with the MASTER DIAL.
Set the temperature and speed for the job
application.
Press the Job button again.
1.
2.
3.
F
ILM
L
OADING
& T
HREADING
The top and bottom rolls of laminating film must be
of the same width and be present simultaneously. A
small amount of adhesive will “squeeze out” during
lamination. Hardened adhesive deposits can damage
the heat rollers. To avoid any damage, select
Low – Laminating on the roller handle, rotate
the rollers at slowest speed with heat on. Refer
to the chapter entitled Operator Maintenance for
instructions regarding removal of the accumulated
adhesive.
Adhesive will deposit on the rollers if:
Only one roll is used.
Different widths of rolls are loaded together.
Either roll is loaded adhesive side against a
heat roller.
One or both rolls of film are allowed to run
completely off its core.
The adhesive side of the film is on the inner side of
the web. The shiny side of clear film must contact
the heat rollers. The dull side of the film contains
the adhesive. Use extreme caution when loading
delustered (matte) film as both sides appear dull.
Always change the top and bottom supply rolls at the
same time. Near the end of each roll of laminating
film is a label stating
Warning-End of Roll. The
appearance of this label on either the top or bottom
roll requires that new rolls of film be installed as soon
as the item presently being laminated completely
exits the rear of the laminator. Do not introduce any
additional items into the laminator when the warning
label is visible.
•
•
•
•