GBC 56FM - Manual (Page 11)

Page 4-1
Operating Instructions
56FM
This chapter describes how to install the laminator.
There are no operator serviceable parts to the
laminator other than periodic cleaning. Refer to the
Operator Maintenance chapter.
WARNING: Do not attempt to service or
repair the laminator. Failure to observe this warning
could result severe personal injury or death.
Disconnect the plug from the receptacle and contact
your dealer/distributor when one or more of the
following has occurred.
The power supply cord or attachment plug is
damaged.
Liquid has been spilled into the laminator.
The laminator is malfunctioning after being
mishandled.
The laminator does not operate as described
in these instructions.
P
RIOR TO
I
NSTALLATION
Inspect the package for damage. Shipping damage
should be brought to the immediate attention of the
delivering carrier.
I
NSTALLATION
To set up the laminator for the first time:
Place the laminator on an even floor capable of
supporting the weight of the laminator loaded
with films and any other materials.
The laminator should be located so that exiting
film drops freely to the floor or to a table that is
lower than the exit point of the laminator.
Accumulation of laminate immediately behind the
laminator as it exits the equipment may cause
the film to wrap around the rollers, jamming the
laminator.
Avoid locating the laminator near sources of heat
or cold.
The laminator should not be in the direct path of
forced heated or cooled air.
•
•
•
•
1.
2.
3.
Connect the attachment plug provided with the
laminator to a suitably grounded outlet only.
Avoid connecting other equipment to the
same branch circuit to which the laminator
is connected, as this may result in nuisance
tripping of circuit breakers or blowing fuses. 4.
4. I
NSTALLATION