GBC 56FM - Manual (Page 24)

Operating Instructions
Page 6-8
56FM
Stop the laminator when the threading card exits
and cut off the card.
Check the film alignment and adjust the tension
as needed.
See the Film Alignment section in this chapter.
W
EBING
A
CCU
S
HIELD
™ F
ILM
The threading card for webbing AccuShield film can
be any stiff print.
IMPORTANT: When starting to laminate, always
start the rollers BEFORE applying pressure to the
rollers to prevent AccuShield build up on the roller.
When stopping, release the pressure on the rollers
BEFORE stopping the motor.
Fig. 6-12. Configuration for AccuShield Film.
To web the laminator with AccuShield film:
Pull the film down, thread it under the idler bar
and drape it over the top heat roller.
7.
8.
1.
Fig. 6-13. AccuShield Draped Over the Top Heat Roller.
Press the straight edge of the threading card
into the film at the nip (the point between the two
pressure rollers) until the card and film is slightly
past the nip.
The film should be wrapped around the leading
edge of the card.
Fig. 6-14. Threading Card Inserted Into the Film.
Press the RUN button on the control panel.
Move the roller pressure handle so that it applies
pressure to the threading card and guide the
card into the machine until the rollers pull it on its
own.
2.
3.
4.