GBC 56FM - Manual (Page 29)

Page 6-13
Operating Instructions
56FM
Press RUN and immediately grasp the release
liner for separation as the board is pulled into the
rollers.
Do not allow the release liner to be pulled into
the rollers.
Continue to pull the liner as the item is pulled into
the pressure rollers.
When the item has cleared the pull rollers, press
STOP.
7.
8.
9.
Remove the laminate and trim out the
encapsulated item.
To run the second pass:
Unweb (unload the films) the laminator first.
Fig. 6-18. Configuration for the Second Pass to Mount the
Item.
Adjust the roller pressure handle to the proper
mounting setting.
Set the speed to 1 fpm (0.3 mpm).
Peel back the leading edge of the release liner of
the laminated item approximately 2 inches
(5 cm).
Place the item on the mount board and tack the
exposed adhesive edge of the item, from the
center out, to the leading edge of the board.
Be sure to not introduce wrinkles or air bubbles.
Tip: The release liner can be removed
completely from short, manageable items and
lightly tacked to the board prior to running it
through the laminator.
Butt the leading edge of the board up against the
rollers.
Hold the laminated item up or drape it over the
safety shield.
7.
1.
2.
3.
4.
5.
6.