GBC 56FM - Manual (Page 33)

Page 6-17
Operating Instructions
56FM
Visually inspect the top and bottom films where
they enter the nip.
The films should be tight against the rollers
at both ends. If they are not, use the tension
adjustment knobs to tighten the loose supply film
brake and run another test.
Ensure that the release liner take-up is keeping
the liner tight against the idler bar.
If it is loose, use the tension adjustment knob to
increase the tension.
Run test materials before laminating good
materials.
4.
5.
6.
C
LEARING A
F
ILM
J
AM
(W
RAP
-
UP
)
Film jams (wrap-ups) may occur if the film is loaded
backwards or if the area at which film exits the
equipment is blocked. The film, when jammed, wraps
around the rollers. Jams also occur if something is
too large to pass through the rollers.
Determine the best course of action to clear the
jam. It may be necessary to rotate the rollers in the
reverse direction. Set the speed to
1. Press and hold
the REVERSE button on the control panel.
CAUTION: Be careful to not cut the pressure rollers
when cutting the film. Failure to observe this notice
can result in damage to the rollers.
To clear a jam:
Immediately press the STOP button to stop the
machine.
Remove the safety shield and feed tray.
Do one of the following.
Pull one of the webs while running the
laminator in reverse.
Cut the film near the rollers, set the
pressure adjustment to
Release, and pull
the film out the back of the machine.
Cut the film near the rollers, set the
pressure adjustment to
Release, grasp
the loose ends of the web, and pull
straight out the front of the machine.
Replace the safety shield and feed tray.
Re-load the film if necessary. See the Loading
Film section in this chapter.
1.
2.
3.
a.
b.
c.
4.
5.