GBC 56FM - Manual (Page 5)

Page 1-1
Operating Instructions
56FM
Your safety, as well as the safety of others is
important. Before you install or use the laminator,
read and follow all the safety notices carefully in
this chapter. In this instruction manual, and on the
laminator, you will find important safety notices
regarding the laminator. Read all of the instructions
and save these instructions for further use.
The safety alert symbol precedes each
safety notice in this manual. The symbol indicates a
potential personal safety hazard to you or others, as
well as laminator or property damage.
This safety alert symbol indicates a potential
electrical shock. It warns you to not open the
laminator and expose yourself to hazardous voltage.
The following warnings are found on the 56FM
laminator.
This safety notice means that you could be seriously
hurt or killed if you open the laminator and expose
yourself to hazardous voltage.
This safety notice means that you could be burned
and your fingers and hands could be trapped and
crushed in the rollers. Clothing, jewelry and long hair
could be caught in the rollers and pull you into them.
This safety notice means that you could cut yourself
if you are not careful.
WARNINGS:
Do not attempt to service or repair the laminator.
Do not connect the laminator to an electrical
supply or attempt to operate the laminator until
you have completely read these instructions.
Maintain these instructions in a convenient
location for future reference.
To guard against injury, the following safety
precautions must be observed when installing and
using the laminator.
Failure to observe these warnings could result in
severe bodily damage or death.
G
ENERAL
S
AFETY
Keep hands, long hair, loose clothing, and articles
such as necklaces or ties, away from the front of
the rollers to avoid entanglement and entrapment
Do not use the laminator for other than its
intended purpose.
The heat rollers can reach temperatures of
300 °F (167 °C). Avoid contact with the heat rollers
during operation and after the laminator has been
turned off.
Do not place the laminator on an uneven surface.
An unstable surface may cause the laminator to
fall resulting in serious bodily injury. Avoid quick
stops, excessive force and uneven floor surfaces
when moving the laminator.
Do not defeat or remove electrical and mechanical
safety equipment such as interlocks, shields or
guards.
Do not insert objects unsuitable for lamination or
expose the equipment to liquids.
•
•
•
•
•
•
•
•
•
1. S
AFETY
ADVERTENCIA ! ATTENTION !
CAUTION
!
RODILLOS
CALIENTES.
PUNTO DE
PINCHAMIENTO.
Mantener manos y
ropa a distancia. ROULEAUX
CHAUDS.
POINT DE
PINCEMENT.
Tenir mains et
vêtements à l'écart. HOT ROLLS.
PINCH POINT.
Keep hands and
clothing away.
ADVERTENCIA !
Riesgo de choque
eléctrico
No abra:
Adentro no hay
piezas reparables
por el usuario.
Mantenimiento
solamente por
personal calificado.
ATTENTION !
Risque de
secousse
électrique.
Ne pas ouvrir:
Pas de pièces
réparables par
l'utilisateur.
Entretien
seulement par
personnel qualifié.
WARNING !
Electrical shock
hazard.
Do not open.
No user
serviceable
parts inside.
Refer servicing to
qualified service
personnel.
ADVERTENCIA !
ATTENTION
!
CAUTION
!
NAVAJA FILOSA.
Mantener manos y
dedos a distancia.
LAME COUPANTE.
Tenir mains et
doigts à l'écart.
SHARP BLADE.
Keep hands and
clothing away.