Loading films with a threading card, General webbing instructions, Webbing thermal films – GBC 56FM User Manual
Page 22: Loading films with a threading card -6, 56fm
Operating Instructions
Page 6-6
56FM
L
OADING
F
ILMS
WITH
A
T
HREADING
C
ARD
The following procedures use a film threading card
that is sometimes provided with new rolls of film. If
one is not provided, a scrap piece of stiff cardboard
or poster board with a straight edge is suitable.
Either can be reused. Instructions are given for
thermal or PSA films. Prior to loading (webbing)
film, remove the safety shield and feed table. Refer
to Safety Shield Removal and Installation and Feed
Table Removal and Installation in this section.
G
ENERAL
W
EBBING
I
NSTRUCTIONS
To prepare the laminator for webbing:
Load the film on the supply shafts as described
in Loading Film Onto the Supply Shafts.
When webbing thermal films, the laminator
should be turned on and at the proper
temperature for the selected film.
Set the roller pressure handle to the
1/2”
Mounting position.
1.
2.
3.
W
EBBING
T
HERMAL
F
ILMS
Fig. 6-7. Web Configuration for Poly-in Thermal Films.
Fig. 6-8. Web Configuration for Poly-out Films.