GBC 56FM - Manual (Page 13)

Page 5-1
Operating Instructions
56FM
5. F
EATURE
G
UIDE
This chapter identifies the main components of the 56FM laminator. The laminator is mounted to a floor stand that
has locking castor wheels.
Fig. 5-1. Component Identification from Front of the 56FM Laminator.
F
RONT OF
L
AMINATOR
T
HERMAL
F
ILM
S
UPPLY
S
HAFT
Holds the thermal film supply on the laminator. It
is set up in the front position. One supply shaft is
provided with the laminator that is used for thermal
or PSA films.
PSA F
ILM
S
UPPLY
S
HAFT
Holds the PSA film supply on the laminator. It is set
up in the rear position as shown in Fig. 5-1.
T
OP
I
DLER
B
AR
The idler bar directs the film to the roller. It assists in
keeping the film flat on the heat rollers.
R
ELEASE
L
INER
T
AKE
-
UP
Rewinds the release liner of pressure sensitive (PSA)
films. The core is supplied with the laminator.
Release liner take-up
PSA film supply shaft
Thermal film supply
shaft position
Top idler bar
Heat pressure rollers
Roller pressure handle
Control panel
Foot switch
Safety shield
Feed table
Bottom film supply
shaft